Then there were three. Today I made a tent fold card with a hanging panel with the contents of door #3. I have heard this card called many different names, tent pop out, frame tent card etc. They are all made the same. You use a die to cut an opening in the card base then put a panel in the inside that hangs free when the card is open.
There is a SVG below for a card of simular style. This one has a rounded corned rectangle opening. It has 2 greeting one Winter Wishes and the other is Happy Birthday.
Materials used
Crafter’s Companion 2022 Advent Calendar Contents of Door 3
Gina K connect glue
Gina K amalgam ink – obsidian
Gina K warm Cocoa
Sentiment of your choice
Crafter’s Companion Torn Paper Note dies
Crafter’s Companion Gnomes paper
Green paper
Cream paper
White card
Triblends -Alpine green, dark Red
Classique Brown grey1
Paper measurements
7x 10 scored at 5
2-½ x 2 scored every ½ inch
4x5 for hanging panel
For mats
2 ½ x 6 ¾
2 ¼ x 6
For layer
2 ¼ x 6 ½
2x5 3/4
Directions
1. Start with a 5x7 card base in the landscape direction.
2. Tack the mat to the front just in the center.
3. Die cut out the shape of your choice. Make sure you leave enough room for tyour greeting.
4. Die cut a frame for the opening if you wish.
5. Glue down the mat and frame into place over the openning.
6. Take 1 of the 1/2 x 2 scored every 1/2 inch and glue the 2 center sections together
7. Glue the tab to the fold of the card.
8.Glue the 4x5 hanging panel to the tab.
9. Take the other 1/2 x 2 and glue the 1st section to the back of the bottom center of the card front. Then glue the last section to the inside bottom center of the card back,
10.Decorate the hanging panel as you wish,
11. Add you greeting to the front.
Comments